MATERIAL SAFETY DATA SHEET
Revised 8/02
Page 1 of 3
PRODUCT: PL-C 13W, 18W, 26W Compact Fluorescent
SECTION 1: MANUFACTUERER
Manufacturer’s Name and Address: Philips Lighting Company
A Division of Philips Electronics
North America Corporation
200 Franklin Square Drive
P.O. Box 6800
Somerset, NJ 08875
Emergency Telephone Number:
Other Information Calls:
(800) 424-9300 CHEMTREC
(732) 563-3197 Safety and Compliance
(732) 563-3089
SECTION 2: HAZARDOUS INGREDIENTS
OSHA PEL
ACGIH
mg/m3
10
APPROX. WT. %
mg/m3
Phosphor Powder
15
1
less than 2
Yttrium Oxide: EU(1314-36-9)
Cerium Magnesium
Aluminate:Tb (67542-72-7)
Hydrogen-3
3
10
less than 50 nCi
less than .02
Mercury (7439-97-6)
.1
.025
Ceiling
8 hr. TWA
SECTION 3: CHEMICAL/PHYSICAL DATA
Not applicable. This item is a light bulb with glass tubes and polycarbonate base.
A division of
Philips Electronics North America Corporation
200 Franklin Square Drive
P.O. Box 6800
Somerset, NJ 08875-6800
Tel: 732.563.3000
PL-C 13W, 18W, 26W Compact Fluorescent
Page 3 of 3
SECTION 7: PRECAUTIONS FOR SAFE HANDLING AND USE
Normal precautions should be taken for collection of broken glass.
Waste Disposal Method: At the end of rated life, when this lamp is removed from service, it will
be subjected to the current Toxic Characteristic Leaching Procedure (TCLP) prescribed by the
Environmental Protection Agency. This test is used to determining whether an item is a
hazardous waste or a non-hazardous waste under current E. P. A. definition. These lamps would
fail the TCLP test and would be considered hazardous under the Universal Waste Rules.
Generators should evaluate all of the disposal options, which may be available in the particular
state in which the generator’s facility is located. The generator should check with federal, state
and local officials for their guidance. Philips encourages recycling of its products by qualified
recyclers.
SECTION 8: CONTROL MEASURES
Respiratory Protection: Appropriate dust mask should be used if large quantities of lamps are
being broken for disposal.
Ventilation: Avoid inhalation of any airborne dust. Provide local exhaust when disposing of
large quantities of lamps.
Hand and Eye Protection: Appropriate hand and eye protection should be worn when disposing
of large quantities of lamps or handling broken lamps.
SECTION 9: REGULATORY INFORMATION
As a product these mercury containing lamps being shipped in the manufacturer’s original
packaging are not regulated by air, truck or ocean shipment. As a waste, these spent fluorescent
lamps would be regulated in various states and local communities. This material safety data sheet
does not constitute “knowledge of the waste”, in certain jurisdictions.
5/5/97
Revised 8/02
S08-97006
|